Granny flat calculator: can you build one, and what will it cost?
Most Australian states let you build a granny flat of 60 to 90 m² through a faster approval path if your lot and design meet the state rules, and a typical 60 m² flat costs about $171,000 to $310,000 all in. Enter your state, lot and flat size below to check the rules for your block and get an itemised estimate.
Can you build it in New South Wales?
- MeetsSize: 60 m² is within the 60 m² limit (floor area measured to the outer face of the external walls, not counting attached decks or carports).
- MeetsLot: 600 m² meets the 450 m² minimum.
- MeetsFrontage: 15 m meets the 12 m minimum for your lot size.
- CheckYour lot band also sets: side setback 0.9 m, rear setback 3 m, site coverage up to 50% and up to 330 m² of floor area for the house and granny flat together.
- Approval path
- Complying development (CDC) from a private certifier or council, if the lot is in a residential zone other than R5, is at least 450 m², has the required street frontage and the design meets every standard.
- Still needed
- If any standard is not met, a development application (DA) to council instead. Only one secondary dwelling per lot, and the lot cannot be subdivided.
- Renting it out
- The Housing SEPP sets no limit on who can live in a secondary dwelling. Normal tenancy law applies.
Sources: NSW Housing SEPP, section 54 and Schedule 1; NSW Planning: secondary dwellings
What it is likely to cost
Likely total: $171,000 to $310,000, typical around $230,000, including GST.
| Item | Low | Typical | High |
|---|---|---|---|
| Build: 60 m² at $2,200 to $3,500 per m² | $132,000 | $168,000 | $210,000 |
| Site works and service connections | $15,000 | $25,000 | $40,000 |
| Design, approvals and certification (fast path) | $3,000 | $6,000 | $12,000 |
| Driveway, paths and landscaping | $5,000 | $10,000 | $20,000 |
| Contingency (10%) | $16,000 | $21,000 | $28,000 |
| Total | $171,000 | $230,000 | $310,000 |
Ranges come from published 2026 Australian cost guides, not from builders we work with. How we calculate.
Granny flat rules by state
The headline rules in each state, read from the official sources on 8 November 2026. Your zone, overlays and council can add to these, so use the links to confirm before you commit.
| State | Called | Max size | Min lot | Approval | Renting | Source |
|---|---|---|---|---|---|---|
| New South Wales | Secondary dwelling | 60 m² | 450 m² | Complying development (CDC) from a private certifier or council, if the lot is in a residential zone other than R5, is at least 450 m², has the required street frontage and the design meets every standard. | The Housing SEPP sets no limit on who can live in a secondary dwelling. Normal tenancy law applies. | NSW Housing SEPP, section 54 and Schedule 1 |
| Victoria | Small second dwelling | 80 m² | No state minimum | No planning permit in residential and rural zones in most cases. A planning permit is needed if the lot is under 300 m² in a residential zone, if an overlay requires one, or if a zone condition applies. | There are no restrictions on who can live in a small second dwelling. Rental laws apply. | Planning Victoria: small second dwellings |
| Queensland | Secondary dwelling | Council sets | No state minimum | Set by your council. Some councils allow a secondary dwelling without development approval if it meets the planning scheme. | Since 26 September 2022 a secondary dwelling can be rented to anyone, related or not. A change in who lives there can trigger extra fire and sound requirements. | Queensland Planning: secondary dwellings |
| Western Australia | Ancillary dwelling | 70 m² | No state minimum | No planning approval if it meets every deemed-to-comply requirement of the R-Codes (including the 70 m² limit and setbacks). The old 350 m² minimum lot size was removed in 2024. | Anyone can live in an ancillary dwelling, including a tenant you rent it to. | WA Planning Reform: granny flats info sheet |
| South Australia | Ancillary accommodation | 70 m² | No state minimum | Development approval through PlanSA. A design that meets the deemed-to-satisfy criteria is assessed faster. Since the 2024 Code Amendment it can be self-contained, with its own kitchen, bathroom and laundry. | Check the current Planning and Design Code and your zone before renting it out. | PlanSA: Ancillary Accommodation Definitions Review (approved amendment) |
| Tasmania | Secondary residence | 60 m² | No state minimum | You may not need a planning permit if the design meets every development standard and no overlay applies. | Check with your council before renting it out. | Tasmanian State Planning Office: ancillary dwellings brochure |
| Australian Capital Territory | Secondary residence | 90 m² | 500 m² | A secondary residence needs development approval. One per block, on a block of at least 500 m². | Check the Territory Plan and your lease before renting it out. | ACT Territory Plan, Residential Zones Policy |
What has changed recently
Many guides online still show the old rules. These are the changes to know about.
- 8 September 2025Victoria raised the small second dwelling limit from 60 m² to 80 m² (Amendment VC282).
- 19 December 2024South Australia's ancillary accommodation changes went live: granny flats can now be self-contained, with a 70 m² limit.
- April 2024Western Australia removed the 350 m² minimum lot size for ancillary dwellings up to 70 m².
- 26 September 2022Queensland allowed secondary dwellings to be rented to anyone, not just family.
- PendingTasmania plans to lift the limit from 60 m² to 90 m². Until it takes effect, 60 m² applies.
Common questions
How much does a granny flat cost in Australia?
A typical 60 m² granny flat built on site costs about $171,000 to $310,000 all in, once site works, service connections, approvals, landscaping and a 10% contingency are added (typical around $230,000). A small modular flat of 40 m² starts lower, at about $117,000. The build price alone is usually $2,200 to $3,500 per m², and the extras are where most budgets go wrong.
How big can a granny flat be?
It depends on the state: 60 m² in NSW, 80 m² in Victoria, 70 m² in WA and SA, 60 m² in Tasmania (90 m² proposed) and 90 m² in the ACT. Queensland has no state-wide limit, so your council's planning scheme sets it.
Do I need council approval for a granny flat?
Usually not a full council application if your block and design meet the state rules: NSW uses a complying development certificate (CDC), Victoria and WA usually need no planning permit, and Tasmania may need none. You always need building approval. In Queensland, South Australia and the ACT you need development approval, and in Queensland your council sets the rules.
Can I rent out my granny flat?
In NSW, Victoria, Queensland and WA, yes: there is no rule limiting who can live in it, and normal tenancy law applies. Queensland made this change on 26 September 2022. In South Australia, Tasmania and the ACT, check the current rules and your council before renting it out.
What is the minimum lot size for a granny flat?
450 m² in NSW for a CDC (with 12 m of street frontage on lots up to 900 m²), and 500 m² in the ACT. Victoria has no minimum, but lots under 300 m² in a residential zone need a planning permit. WA removed its minimum in 2024.
Is this calculator an approval?
No. It checks your idea against the headline state rules and gives a cost range from published guides, so you can decide whether it is worth taking further. Zones, overlays such as heritage, bushfire or flood, and council rules can change the answer. A certifier or your council makes the formal decision.
Where these figures come from
Rules: the official state sources linked in the table, read on 8 November 2026. Costs: published 2026 Australian cost guides, read on 8 November 2026:
- What's The Damage: granny flat cost (updated November 2026)
- The Quote Yard: granny flat cost NSW (published August 2026)
- Three Birds Renovations: granny flat cost 2026 (May 2026)
PlanHome is a design and feasibility tool, not a planning approval or a quote. How we calculate.
Last updated 8 November 2026.
